Xylem P2000516 Marlow Series Impeller Static Balancing I Uživatelský manuál stáhnout pdf (Strana 2)

FIGURE 1

STEP 1 — When cutting the impeller O.D. it is

suggested that the tail stock of the lathe be utilized

and act as a stablizer.

FIGURE 3

STEP 2 — After impeller has been cut to size, make

certain that all burrs are removed. Insert mandril

into impeller and place on balancing ways. Spin the

impeller lightly and allow to turn until it stops rocking.

FIGURE 2

For holding the impeller in the chuck. Note the use of

a at block of wood between impeller and blunt tail

stock.

FIGURE 4

Make a chalk mark at the bottom center of the

impeller. This is the unbalanced point.

1 2 3 4

Žádné komentáře

Xylem P2000516 Marlow Series Impeller Static Balancing I Uživatelský manuál Strana 2